A Paper Plane Ready To Glide
A paper airplane falls down due to gravity and glides forward through the air at the same time. We’ll measure the glide ratio the ratio of the distance glided to the distance fallen. Material A paper airplane A meter stick String Assembly Fold a paper plane. (See the animations on this site for the Nakamura, in the Gliders Section.) To Do and Notice Fly your paper plane.Trim it until it glides in a straight line smoothly to the floor.
All paper airplane gliders have a natural speed and angle at which they will steadily glide down to the ground.Fly them too slowly and the nose will drop and the plane will dive, fly them too fast and the nose will rise and the plane will climb or stall.
If you cannot find any speed to keep the nose from falling into the ground bend the back of the wing up. If the nose points up and then stalls at all speeds bend the back of the wing down. Practice and learn to throw your plane at the exact right speed and angle so that it will smoothly fly to the ground.
We call this the Goldilock’s throw, not too fast, not too slow, just right. Stretch a string, horizontally, just below chin height. Measure the height, H, of this string above the floor, perhaps H = 1.5 m. Launch your plane over this string.
Note the point where the plane hits the floor.Measure the horizontal distance from the string to where the plane hit the floor, D.Compute the glide ratio, D/H.Find an airplane design and trim that gives the best glide ratio.
What’s Going On? As a plane falls under gravity it pushes air backward and down to keep itself aloft and to move forward.
Each different airplane has a different glide ratio. Even the same airplane when trimmed differently a have a different glide ratio.So What? Once it gets up to flying speed, after a 300 m long drop, the human body has a glide ratio of 1. That means that if it falls a kilometer it can glide a kilometer forward. A modern high performance glider will have a glide ratio over 40. It will fly 40 km forward for every kilometer it drops.
Originally posted 2012-05-15 20:28:41. Republished by Blog Post Promoter